2 824120
Table of Contents
Warnings 2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Setup 4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Pressure Relief Procedure 5. . . . . . . . . . . . . . . . . . . . . . .
Operation 5. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Troubleshooting 8. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Pump Service 10. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parts Drawings and Lists
3040 and 3235 Pressure Washers 12. . . . . . . . . . . . .
Pump for 3040 and 3235 Pressure Washers 14. . . .
3540 Pressure Washer 16. . . . . . . . . . . . . . . . . . . . . . .
Pump for 3540 and 4043 Pressure Washers 18. . . .
4043 Pressure Washer 22. . . . . . . . . . . . . . . . . . . . . . .
Technical Data 27. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Sherwin–Williams Standard Warranty 28. . . . . . . . . . . .
Phone Number 28. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Symbols
Warning Symbol
WARNING
This symbol alerts you to the possibility of serious
injury or death if you do not follow the instructions.
Caution Symbol
CAUTION
This symbol alerts you to the possibility of damage to
or destruction of equipment if you do not follow the
instructions.
D Do not point gun at anyone or at any part of body.
D Fluid injected into the skin might look like just a cut, but it is a serious injury. Get emergency
medical attention.
WARNING
WARNING
INJECTION HAZARD
Spray from the gun, leaks or ruptured components can inject fluid into your body and cause serious
injury. Fluid splashed in the eyes or on the skin can also cause serious injury.
D Do not stop or deflect leaks with hand, body, glove or rag.
D Do not put hand or fingers over spray tip.
D Tighten fluid connections before starting equipment.
D Engage the gun trigger safety when you stop spraying.
D Follow Pressure Relief Procedure on page 5 if spray tip clogs and before cleaning, checking or
servicing equipment.
D Repair or replace worn or damaged parts immediately.
D Check hoses, tubes, and coupling daily. Do not repair high-pressure couplings; replace entire
hose. Fluid hoses must have spring guards on both ends to prevent kinks and rupture.
To Next Page
Loading...