Section 9 Periodical inspections and services
.
7. Exchanging the Cooling Water
Do not open the radiator cap while the engine
is running or immediately after the engine
stops. Open it after the engine stops and has
cooled down. If not, hot water may spurt out
and you may get burnt.
Inspection
Open the bonnet and check that the coolant in
the reserve tank is between the upper limit and
lower limit. If the level is too low, replenish the
coolant from the water feeler port of the
reserve tank.
Exchange
(1) Remove the radiator cap, loosen the band
and remove the flat head pin for drain and
discharge the water in the radiator
completely.
Danger
Fuel Filter
Cleaning and Replacement
(1) Turn the fuel tap to the C (closed)
position.
(2) Remove the filter cup and remove the
water and dust in the filter cup.
(3) After completion of filter cleaning, install it
to the original position and turn the fuel tap
to the O (opened) position
The fuel feed pump of this machine is driven
from the cam shaft. After it is operated for
cleaning or replacement, remove the cap and
discharge the air in the filter cup.
(4) Replace the fuel filter every 200 hours of
operation.
5756
To Next Page
Loading...
