What to do if Shimadzu Diagnostic Equipment shows error 'Starter is not working'?
If the Shimadzu Diagnostic Equipment displays the error message 'Starter is not working,' it means the starter is not working during fluoroscopy. To resolve this, reduce the set value of mAs or sec.
What to do if Shimadzu Diagnostic Equipment shows error 'I.F. OVER'?
If the Shimadzu Diagnostic Equipment displays the error message 'I.F. OVER,' it means there is an abnormal filament heating current. To resolve this, reduce the set value.
How to emergency stop the Shimadzu Sonialvision Safire Diagnostic Equipment table operation?
To perform an emergency stop on the Shimadzu diagnostic table operation, press the stop switch on either the diagnostic table console or the diagnostic table itself.
What to do if Shimadzu Sonialvision Safire Diagnostic Equipment shows error 'AEC OVER'?
If the Shimadzu Diagnostic Equipment displays the error message 'AEC OVER,' it indicates that AEC failed and AEC backup was used during AEC radiography. To resolve this, increase the radiography tube voltage or extend the radiography time.
What to do if Shimadzu Sonialvision Safire shows error 'mAs too small'?
General| Brand | Shimadzu |
|---|---|
| Model | Sonialvision Safire |
| Category | Diagnostic Equipment |
| Language | English |
Details the overall system components and layout.
Explains the controls and functions of the diagnostic table console.
Describes the operation and controls of the X-ray high voltage generator.
Outlines the main display and controls of the digital image processor.
Provides a visual guide to the system's operational sequence.
Step-by-step guide for powering on the system and its components.
Instructions for properly closing active studies and powering off the system.
Procedures for calibrating the Flat Panel Detector (FPD) to ensure image quality.
Alternative method to perform FPD calibration using the system's context menu.
Process for entering patient information to initiate a new study.
Method for quickly entering patient data during emergency situations.
How to select the appropriate study type based on imaging needs.
Steps to configure parameters for radiography and fluoroscopy procedures.
Detailed procedure for performing SPOT and SERIAL radiography.
Instructions for performing Digital Subtraction Angiography (DSA) if the option is available.
Guide for operating the digital tomography function, including parameter setup.
Methods for printing acquired images from the system.
Procedures for printing specific images using the context menu.
How to print entire patient files or selected studies from the patient list.
Instructions for transmitting images and studies using DICOM network or CD-R.
Steps to properly close the current patient study.
Procedures for using emergency stop and recovering the system.
Lists common error messages from the X-ray generator and their solutions.
Steps to take for system recovery and verification after a power interruption.
To Next Page