Need help?Do you have a question about the Shimadzu TOC-V CPN and is the answer not in the manual?
General| Type | TOC Analyzer |
|---|---|
| Weight | Approx. 35 kg |
| Method | Catalytic combustion oxidation/non-dispersive infrared gas analysis |
| Measurement Principle | Combustion catalytic oxidation method |
| Detection Method | Non-Dispersive Infrared (NDIR) Detection |
| TC Measurement Range | 0-30, 000 mg/L |
| NPOC Measurement Range | 0-30, 000 mg/L |
| Detection Limit | 4 μg/L (as Carbon) |
| Measurement Time | Approx. 4 minutes |
| Sample Introduction | Automatic via autosampler |
| Carrier Gas | Oxygen (O2) |
| Power Supply | AC 100-240 V, 50/60 Hz |
| Measurement Range | 0-30, 000 mg/L |
Covers measurement functions, including Sample Table Editor and H/W Settings.
Details system administration, user authentication, and audit trail features.
Instructions on how to access the user manual document.
Step-by-step guide for generating calibration curve files for analysis.
Procedure for defining analysis parameters and creating method files.
Process for setting up and configuring sample runs.
Managing and importing schedule files for automated sample sequences.
Associating specific vial numbers with samples in the sample table.
Procedure to establish a connection between the software and the instrument.
Initiating the analysis process and configuring instrument standby modes.
Overview of the Sample Window display during active measurement.
How to modify sample table entries while analysis is in progress.
Methods to interrupt or halt the ongoing analysis process.
To Next Page