Why won't my Shindaiwa 3 Series engine start?
There are several reasons why your Shindaiwa Welding System engine might not be starting: * The fuel lever on the fuel strainer may be closed. Open the fuel lever. * There might be insufficient fuel. Replenish the fuel. * A fuse may be burnt. Replace the fuse. * The fuel may be contaminated by water or dust. Drain the water or clean the fuel tank and fuel strainer.
How to fix a Shindaiwa Welding System when the starter motor does not turn?
If the starter motor of your Shindaiwa Welding System isn't turning, it could be due to: * A weak battery: Recharge the battery. * A dead battery: Replace the battery.
What to do if the welding arc is weak on my Shindaiwa 3 Series Welding System?
A weak welding arc on your Shindaiwa Welding System can be caused by several factors: * The Idle Control Switch position is incorrectly set to [ECO] mode. Turn it to [AUTO] or [HIGH] mode. * The Output Control Dial position is wrong. Turn the dial clockwise. * There is improper connection of cables. Connect them securely. * The cable diameter is improper. Replace the cables based on the Welding Cable Selection. * There is improper connection to the base material. Connect securely. * Simultaneous use of welding and generating exceeds the maximum permissible load. Stop using AC Power output.
Why is my Shindaiwa 3 Series Welding System producing excessive black smoke?
Excessive black smoke from the exhaust muffler of your Shindaiwa Welding System can be due to: * Overloaded use: Operate the machine within the rated output. * A dirty air cleaner: Clean or replace the air cleaner.
What to do if Shindaiwa Welding System engine starts but stalls immediately?
If your Shindaiwa Welding System's engine starts but stalls immediately, it could be due to: * Insufficient oil: Replenish the oil. * Insufficient coolant/water: Replenish the coolant/water. * Inability to charge: Repair the system.
How to reduce excessive welding arc on Shindaiwa Welding System?
An excessive welding arc on your Shindaiwa Welding System can be reduced by: * Turning the Idle Control Switch to [ECO] mode if it's set to [AUTO] or [HIGH] mode. * Turning the Output Control Dial counterclockwise if its position is wrong.
Why is the AC output weak on my Shindaiwa Welding System?
A weak AC output on your Shindaiwa Welding System can occur if: * The rated current of the load exceeds the rated output. Adjust according to OUTPUT LIMITATION. * Welding and generating are used simultaneously, exceeding the maximum permissible load. Stop using them simultaneously.
What to do if my Shindaiwa 3 Series Welding System engine does not stop?
If your Shindaiwa Welding System engine does not stop, it could be due to a Stop Solenoid malfunction. Turn the fuel lever to [CLOSE] to stop the engine and then repair the solenoid.
How to restore AC output on a Shindaiwa Welding System?
If there is no AC output from your Shindaiwa Welding System, check if the breaker (1-P or 3-P or ELCB) is in the [OFF] position. If so, turn it to [ON].
Why isn't the IDLE feature working on my Shindaiwa 3 Series?
The IDLE feature on your Shindaiwa Welding System may not be working because: * There is a welding cables short circuit. Repair the short circuit. * The power consumption of the load is 0.5A or below. Set the Idle Control to [HIGH] mode.
General| Brand | Shindaiwa |
|---|---|
| Model | 3 Series |
| Category | Welding System |
| Language | English |
To Next Page
