EB600RT OPERATION
X7505200905 23
© 11/2018 ECHO Inc.
1. Throttle Lever
Move throttle lever (A) to IDLE
position.
2. Choke
Move choke (B) UP to COLD
START ( ) position.
3. Purge Bulb
Pump purge bulb (C) until fuel is
visible. Pump bulb an additional
4 or 5 times.
4. Recoil Starter
Pull recoil starter handle (D) until engine fires, or a maximum of 5 pulls
5. Choke
After engine fires (or 5 pulls),
move choke lever back to RUN
( ) position, then pull starter
handle/rope until engine starts
and runs. Allow unit to warm up
at idle for several minutes.
Note: If engine does not start
with choke in “RUN”
position after 5 pulls,
move choke to COLD
START ( ) position, and
repeat steps 3- 5.
6. Throttle Lever
Allow engine to warm up for several minutes before use.
7. Throttle Lever
After engine warm-up, squeeze throttle trigger, then move throttle lever to
set desired operating speed.
To Next Page
Loading...
