Shopsmith MARK V - Page 40

SHOPSMITH MARK V 845180
6530 Poe Avenue
Dayton, Ohio 45414
www.shopsmith.com
845180 Rev B 8/01
©
2001 Shopsmith, Inc.
All Rights Reserved
Printed In U.S.A.
MAINTENANCE SCHEDULE
• Clean the Saw Guards & Sanding Disc.
Refer to Maintaining Accessories.
• Sharpen Saw Blades, Drill Bits & Lathe
Chisels.
• Clean the MARK V.
Refer to Cleaning.
• Wax the MARK V.
Refer to Waxing.
• Repeat the preceding steps.
PLUS
Check the action on the anti-kickback
system and the Lower Saw Guard,
wax the Splitter on the Upper Saw
Guard & lubricate the Drill Chuck.
Refer to Maintaining Accessories.
Check the alignment & adjustment of
the Headrest & Carriage Locks, Work-
table Stops, Table Tilt Indicator, Miter
Gauge Slots, Miter Gauge, Rip Fence,
Extension Table & Lathe Centers.
Refer to Alignment for your MARK V
model.
• Repeat the preceding steps.
PLUS
Lubricate the Floating Sheaves on the
Idler & Motor Shafts
Refer to Lubricating.
• Repeat the preceding steps.
• Lubricate the Headstock Lock & Car-
riage Lock.
Refer to Lubricating.
As Needed
Every 5 Hours of Running Time
Every 10 Hours of Running Time
Every 25 Hours of Running Time
Once A Year (if not used)
Every 50 Hours of Running Time
Once A Year (if not used)