INTRODUCTION
3
Please read the instructions in details before you use, and follow the contents to do the most proper
installation. After you have made the proper installation, please keep this instruction well for your
references at any time.
If you would like to do any changes for the installation regarding this product, please must make sure if
the specifications are correct or not. Otherwise, the incorrect installation will probably result in the
permanent damage to this product, therefore, please use it with cautions.
Cautions:
1. Absolutely not to do the installation that exceeds the specifications of this products because it will
result in affecting the life and the capacity with regard to this product.
2. Keep away from the place that wets in rain directly if installing at outside.
3. Do not clean the appearance of the column speaker with an organic solvent or alcoholic detergent.
4. Do not repair or disassemble the product yourself if there is any damage or unusual situation, please
should contact the person in charge of service immediately.
CS-308 is a professional column array speaker developed by SHOW. With 1.0mm mesh and 0.8mm
grille, it can effectively protect unit from external damage and prevent dust into the speaker. Cabinet is
made by plywood with light weight and solid structure. Cabinet surface is sprayed fine sand paint to
make delicate. touch. 8 pieces 3 " full-range horn unit with linear paper cone , cloth surrounding can
achieve high sensitivity. The system apply power transformers to switch power, effectively protect the
units. To prevent high power input signal damage units, they can be used in parallel to avoid causing
damage to the PA amplifier with low impedance. Locked bracket screws to fixed plate inside cabinet.
The fixing plate with 3 mm thick iron can effective decompose the bracket pull force.
CS-308
CS-312
CS-304
To Next Page
Loading...