step 8
Showerbuddy SB3T page 8
step 7
To attach the neck rest, insert the plastic
sleeve into the neck rest height
adjustment tube.
Insert the neck rest into the sleeve on the
neck rest height adjustment tube. Adjust
to the required length and secure in the
correct position. By screwing the neck
rest handle in a clockwise direction the
neck rest height adjustment tube
connector will tighten and secure the
neck rest in position.
NOTE
- The neck rest should always be used and
adjusted to suit the specific user.
Insert the footrests as shown by simply
dropping each leg into the tube holder.
Make sure each leg is fully located in the slot
at the rear to prevent the leg from roating.
To rotated the leg simply lift and rotate out
of the way.
To Next Page
Loading...