Seat Height Adjustment
To raise or lower the seat height depress the
push pin in the caster leg as shown and move
the caster leg up or down to suit the user
height requirement.
Ensure all push pins are set at the same
height location to ensure the wheeled base is
level and does not rock or feel unstable. The
chair must sit on all 4 caster wheels.
WARNING
If you find a push pin is not fully engaging or
“popping out” into position after use DO NOT
use the chair. Consult your supplier for
adjustment.
The chair may be adjusted to have a higher
seat height at the front and lower at the back
to suit user requirements. This can be
accommodated by adjusting the front caster
leg only to be extended further than the rear
caster leg. Under no circumstances should
there be more than 1-adjustment position
difference between front and rear
(approximately 20mm).
In every circumstance the chair must be
adjusted with all caster wheels set to touch
the ground at the same time otherwise the
chair will rock and will not be stable.
DO NOT use the chair unless all 4 caster
wheels are firmly on the ground.
SB6 Roll-in Shower Chair 12
To Next Page
Loading...