Safety Restraints
A safety restraint (part# 500-270) is supplied
with the chair and should be used, it can also
be used as a waist restraint if preferred. You
can also purchase an additional harness if
you require waist and chest restraints.
To fit or remove the restraints unscrew the
clamp and remove the belt. Make sure the
clamp is tight enough to prevent the belt
pulling though when refitting.
Clamp bars (part #500-106) are fitted to the
chair back (part #500-022) and at the lower
lap area on the seat frame (part #500-021).
Before use, adjust the length of the safety
restraints to suit the user.
SB6 Roll-in Shower Chair 16
A Commode Deflector (part #500-074) can
be fitted to the front of the commode bucket
if required, after the bucket has been fitted
to the chair, allowing the user to transfer
easily to the chair prior to fitting the splash
guard.
The commode cover (part# 500-073) should
be used when transferring contents to the
toilet to avoid spils.
500-270
To Next Page
Loading...