3.2 Clear/Exit
Clear:
The function of this button varies with the state of the device.
● Pressing the button clears the manual entry for the corresponding fader
● Pressing and holding the button for 3 seconds clears all manual entries for chases, faders, scenes and
groups.
Exit:
Press this button to exit the program or delete mode without saving your settings.
3.3 Blackout
Press this button to kill all output.
3.4 Pause
Press this button to pause all running chases.
3.5 Program
Press this button to enter Program-mode.
3.6 Add
Press this button to add a step while programming a chase or chase group.
3.7 All
When a chase is running, press this button to adjust the speed and slope for al
the steps in the chase.
3.8 Del
Use this button to delete a scene/ chase/ chase group/ step while
programming.
3.9 Latch
Press this button to latch two or more scenes/ chases/ chase groups to run
simultaneously.
3.10 Swap
Press this button to swap the running of a different scene/ chase/ chase
group (only one at a time).
3.11 Flash/Slopeset
Flash:
Press and hold this button, then select a scene, chase or chase group to run it
As long as the flash button is pressed.
Slopeset:
Press this button to assign a slope to a channel. The pan/ tilt channels controlled
by the jog wheels have a fixed slope.
3.12 Music/Insert
When a chase is running, press this button to activate the sound mode.
Press this button to insert a step when programming.
3.13 Auto/Language
Auto:
Auto mode is the default chase running mode. Use this button to switch between sound mode and auto
mode with preset speed and slope.
Language:
Press the program (3.7) button first and then press this button to switch between English and German
language.
To Next Page
Loading...
