▲Operation
1. Check the machine and accessories, ensure it is in good status. Place the machine on a flat
surface, tilting may result in inaccurate water level alarm. Lock wheels to keep from moving.
2. Open the upper cover and filling the machine with water until reached the Max. water level.
CREEPER ICE water tank is 55L, CREEPER ICE PLUS is 75L.
3. Connect the machine to suitable rated power supply. Please ensure power supply meets the
requirement. Always connect the machine to a protected circuit and ensure it is properly
grounded.
4. CREEPER ICE with dual power supply design, users can use single or dual power to heating
up. Whenever in single or dual power mode, the main power input must connected, the
corresponding LED indicator will light up when power supply connected successfully.
5. CREEPER ICE PLUS use industrial power socket. Turn on the air switch when power connected,
and the LED indicator will light up.
6. Open the upper cover, put the dry ice into basket. Close the upper cover and lock it. If filling
the ice basket outside of machine, please make sure it well fitted when put it back to machine.
7. When machine was ready, water reached set temp., press VOLUME the machine will start to
work. When water temp. lower than 30 , machine will stop working automatically, operator
can also press STOP to stop the machine.
8. If need to transport the machine after show, please drain the remaining water when it is
cool down. Please be aware of the hot water.
To Next Page
Loading...