Showven CREEPER ICE PLUS - Operation Panel Details; Control Area and Interface Display; Error Codes and Setting Menu

▲Operation Panel
1. Control button area
MENU: switch through setup menu;
+: parameter up, multiplex “TIMER” (Timer Fog output when in main interface);
-: parameter down, multiplex “VOLUME” (Continuous Fog output when in main interface);
ENTER: confirm and save parameters (screen will blink once when save successfully); multiplex
“STOP”.
NOTE: Screen will switch to main interface automatically if not press any button in 15s.
▲Interface
1. Main interface:
First Line: DMX address and Fog Output Volume, “:”blinks when there is DMX in signal.
Second Line: water temperature, when temp. reached set temp. it will shows “READY”means
the machine is ready to firing, press “VOLUME”to generate fog.
2. Error Information:
Error information
Explanation
E1 No Water
Filling the water tank
E2 Temp. Sensor
Temp. Sensor loose or sensor cutting out
E5 K Temp. Over
Circuit board malfunction
E6 Heat Fail
Heater broken or circuit board malfunction.
3. Setting Menu
Press “MENU” switch through setup menu.
Items
Value
Explanation
DMX Address
1~511
DMX address setup
Temp. Setup
60-80°
Water TEMP. Set, the higher
the temp. the longer the
fog output
Fog Volume Output
50-100%
Fog output volume increase
as the value increase
Wireless Set
ON / OFF
Wireless function set
Language
中文/English
Language switch