SP-110-SS30 6 10/25/2011
GPS as a Heading Source (no Compass)
A compass is not used with this system.
Display will show COG heading from GPS – example C123. If a compass is
reconnected the display will change to compass heading – example H123.
Refer to Basic Operation pages 3 or 4 to use the pilot.
Basic Trouble Shooting
Display does not indicate
Check supply voltage is 12 volts DC (Red and Black)
Check in-line fuse
Display shows heading but rudder does not move when AUTO is selected
Check MANUAL light is on.
Press AUTO. Check AUTO light is on
Check voltage at the motor connections (yellow & yellow/black wires) when ◄ or
► is pressed several times.
Check motor or pump set wiring
Check motor brushes
Check the hydraulic system:
1. Ensure there is sufficient hydraulic fluid.
2. Purge the system of possible air locks / contamination.
3. Ensure that any flow restricting valves are not completely closed.
4. Check all pipe connections for leaks.
Autopilot cannot be used in Wind Steering Mode
Check Wind Speed & Direction system is switched on
Check wire connections from wind system to autopilot
If any fault cannot be found, consult your dealer.
To Next Page
Loading...