SP-110-SS30 7 10/25/2011
Warranty
SI-TEX products are thoroughly inspected and tested before shipment from
the factory and are warranted to be free of defects in workmanship and
materials for a period of one year from the date of shipment from the factory.
This warranty is extended to and is solely for the benefit of the original
consumer purchaser.
All units in need of repair will be repaired without charge to the purchaser
during the above mentioned period in accordance with the following terms and
conditions:
1. The defective unit is returned "freight prepaid" to Si-Tex Marine
Electronics 25 Enterprise Zone Drive, Suite #2 Riverhead, NY 11901.
2. Proof of purchase is supplied and original Serial Numbers on
equipment have not been changed.
3. Information is provided regarding the nature of the failure or problem
occurring.
4. A return address is supplied to enable the equipment to be returned
by road freight. Any other means of transport will be charged to the
customers account and must be paid in advance.
This warranty does not cover defects or damages caused by unauthorised
service or damage through accident, misuse or abuse. The owner is also
responsible for providing reasonable maintenance and weather protection
of the equipment.
SI-TEX shall not be liable for damage or loss incurred resulting from the
use and operation of this product. SI-TEX reserves the right to make
changes or improvements to later models without incurring the obligation
to install similar changes to equipment already supplied. Some states do
not allow the exclusion or limitation of incidental or consequential
damages; therefore the above limitations or exclusions may not apply to
you. This warranty gives you specific legal rights and you may also have
other rights, which vary from state to state.
Additional Information Refer to SI-TEXwebsite
To Previous Page
Loading...
