II -
ASSEMBLING BOWL AND CISTERN
Fix screws at the bottom of the cistern
(see order of parts below)
Position the latex foam gasket on the nut (g)
Position the cistern on the bowl and secure it with wing nuts
I - INSTALLATION
Position the mechanism in the cistern
and secure it in place with the nut (g)
Manually screw the ush valve nut (g)
until it is in contact with the ceramic.
If necessary give an extra quarter
turn (maximum) with the appropriate
spanner.
NB : Excessive tightening can damage
the mechanism and would not be
covered by the guarantee.
Bottom of cistern
Wall of bowl
Conical seal
Hexagon nut
Washer
Wing nut
Washer
M6x78 screw
To Next Page
Loading...
