III - INSTALLATION OF BUTTON
IV - MAINTENANCE
Changing the valve gasket
After having opened the cistern,
turn the mechanism 90° to
separate it from its strainer
Change the valve gasket
Reposition the mechanism,
locking it into the strainer
Close the cistern again.
Valve gasket
Strainer
Once the set-up has been completed, place button (a) on lid and screw button nut (c),
(if the hole in the lid (D) is > 38 mm and < 45 mm, remove the escutcheon (b))
Clip cable case
Place lid back on top of cistern
To Next Page
Loading...
