3
Tools required (not spplied):
• Slotted screwdriver and adjustable
spanner.
FITTINGS SUPPLIED
Advice:
• Before you Start
- Read these instructions carefully.
- Check the pack and make sure you have all the parts on the pack list.
- Remove all packaging from pottery and check for surface damage or defects.
- Prepare a firm working surface (e.g; floor or bench) for cistern assembly, covering work
surface with cloth to prevent scratching the glazed faces of the cistern.
• Care & Use
- Wipe clean with a soft damp cloth around the WC suite.
- Never use scourers or abrasives.
• Water connection
- Water connection should be made only with an approved tap connector (not supplied).
Preparatory sealing compounds should not be used.
• Maintenance
Your new product is designed to have a long life span, however under certain conditions
e.g. hard water, «water hammer», excessive water pressure or installation debris in the
water pipe, it is possible that the life span of the diaphragm washer will be reduced.
To ensure long lasting customer satisfaction, a spare diaphragm washer is included in
this pack.
Pushbutton (1)
Valve body (1)
Rubber Washer (1)
Fixing nut (1)
Sealing Gasket (1)
Inlet valve (1)
Inlet Rubber Washer (1)
Backnut (1)
a
b
c
d
e
f
g
h
PARTS SUPPLIED
Spanner (1)
Bolt (2)
Sealing washer (2)
Washer (4)
Nut (2)
Butterfly nut (2)
Spare Diaphragm Washer (1)
i
j
k
l
m
n
o
To Next Page
Loading...
Need help?
General
