Side-Power 8950G - User Manual

To Next Page

Installation guide for Sidepower single control panels. Issue 5. © Sleipner Motor AS 2007 Page 1

SIDEPOWER

Thrusters

Installation guide for single control panels types: 8950G & 8960G

Installasjons veiledning for kontroll panel typer: 8950G & 8960G

We Sleipner Motor AS declare that these control panels complies with health and safety require-

ments according to the Directive 89/336/EEC of 23 May 1989 amended by 92/31/EEC and 93/68/EEC.

Vi Sleipner Motor AS bekrefter att disse kontroll panel tilfredstiller krav til helse og sikkerhet i

følge Direktiv 89/336/EEC av 23 mai 1989 med tillegg av 92/31/EEC og 93/68/EEC.

Sleipner Motor AS garantiert, daß die Panels die Gesundheits- und Sicherheitsanforderungen

Important ! These panels will only work with Sidepower electric thrusters with a built in electronic

control box and a 4/5 lead control cable system. These panels are waterproof from the front

end when correctly installed. However, you must ensure that they can never be submerged

in water as this might cause a shortcircuit and thereby causing the thruster to start unintededly.

Viktig ! Disse kontroll panel fungerer bare med Sidepower elektriske trustere med integrert

elektronisk kontroll boks og 4/5 leders kontroll kabel system. Disse panelene er vantette

fra fronten når de er korrekt installert. Men, de må aldri stå slik att de er under vann da dette

kan gi en kortslutning som kan føre til selvstarting av trusteren.

Wichtig ! Die Panels funktionieren nur mit elektrischen Sidepower Systemen mit integrierter

elektronischer Kontrolleinheit und einem Kabelstrang mit 4/5 Leitungen. Die Panels sind

bei korrektem Einbau an der Vorderseite wasserdicht. Trotzdem muß sichergestellt sein,

daß das Panel nicht unter Wasser kommt, da dies zu einem Kurzschluß führen kann.

Hierdurch kann es zu einem unbeabsichtigten Start des Thrusters kommen.

Installationsanleitung für Steuerpanele, Typ: 8950G & 8960G

Partslist referring to drawing on next page

Deleliste refererer til tegning på neste side

Teileliste für Zeichnung Seite 2

Ref: Pcs. Parts: Deler: Teile:

1 1 x Control panel Kontrollpanel Steuerpanel

2 1 x Gasket Pakning Dichtung

3 4 x Screws (A4) Skruer (A4) Schraube (A4)

4 4 x Corner clips Hjørne klips Eckstück

Need help?

Do you have a question about the Side-Power 8950G and is the answer not in the manual?

Summary

Important Information and Compliance

Critical Operational Warnings

Panels only work with Sidepower thrusters, are waterproof from front, but must not be submerged.

CE Compliance Declaration

Declaration of compliance with health and safety requirements according to EU directives.

Installation Procedure

Panel Placement and Preparation

Find a comfortable position, mark and cut the area, use sealant if edges are damaged.

Connecting Control Cables

Connect the panel to the thruster's control cable and the automatic main switch.

Securing the Panel

Insert the panel, screw it in place, and press the corner clips into their slots.

Troubleshooting Reverse Operation

Swap grey and blue control cables if the thruster runs in the opposite direction.