SIDESHIFT INSTALLATION GUIDE V1.9
STEP 4: CONNECT BATTERIES
Fit battery protectors and then shrink tube over each battery lead at the battery end.
Install compression terminals. See How To Install Compression Terminals on page
19 for instructions.
Attach positive cable (connected to “BATTERY POS” post on motor controller) to the
positive post of the battery. Slip battery protector over terminal.
Repeat steps for “BATTERY NEG” cable.
STEP 5: CONNECT THRUSTER TO MOTOR CONTROL MODULE
NOTE: Motor power cable polarity is not identified. If thrusters operate
in opposite direction from joystick, reverse cable
connections on motor controller.
If thruster power cables are too long, cut them to length. Be sure that they are
neatly routed, and comfortably reach the motor controller terminals. Leave some
slack to make installation easier.
Install compression terminals. See How To Install Compression Terminals on page
19 for instructions.
Connect one cable to “MOTOR 1” and the other to “MOTOR 2”.
To Next Page
Loading...