Sideshift HB350 - Safety Warnings; Required Tools

SIDESHIFT INSTALLATION GUIDE V1.9
2
Safety warnings
WARNING: To prevent overheating when operating the Sideshift
thruster, run for a maximum of 20-30 seconds at a time,
then allow to cool for at least 10 seconds before further
operation.
WARNING: Ensure thruster battery switch is turned off when conducting
maintenance and repair of the thruster.
WARNING: Use extreme caution when swimmers are in the area of the thruster.
Turn off ignition and avoid contact with thruster props when boat is
stationary.
WARNING: When operating out-of-water do not run thruster for longer than
5 seconds to prevent overheating.
WARNING: If conducting an in-water installation, use a cordless drill only, as a
corded drill can present an electrocution hazard.
Required Tools
 Heat gun

3
/
8
” drive cordless driver
 3/8” hex socket
 Wire stripper
 Wire crimper
 SAE wrench set 3/8” to 3/4”
 Pliers
 Drill bits up to ½”
 Caulking gun
 Marine sealant
 1 ¼” and 2 ½” hole saw