position, the spindle will stop.
4. When you control the mill and need quickly stop the spindle speed, you can clap the
emergency stop switch (A), as this time the fault yellow light ( E) will bright.
If you need restart the mill you need turn the F/O/R switch (D) to “0” position, then
control as 1-2-3 steps.
5. Fine feeding function: When lock the Lock small handwheel (A), then the control handle
(B) can not useable. Turn the fine feeding handwheel (C) the spindle will micro remove.
Notice:
After using should turn the power switch to position ‘0’ and pull out the plug from
socket.
To Next Page
Loading...
