Siemens 3100 - Using for the First Time; The first wash cycle (without laundry); Setting the programme, starting the programme, programme sequence; Setting the wash programme

The first wash cycle
(without laundry]
Carry
out
the
first
wash
cycle
without
haun-
dry to remove any residual water from tac-
Tests.
1
Снеск
that
the
transit
bolts
have
bean
semavaed
from
the
back
of
tha
machinelsae
installation
instructions].
2 Turn the tap ON,
3. Pull the detergent drawer aut as far as it
will
до,
|
4 Pour hall a measuring cup into compart:
ment Ë. Со nat use detergents designed
for wool of delicate wash as this produces
excessive foam.
& Turn the programme selector clockwise ta
programme В twhites/colourads, narmalj.
B, Set the temperature selector to ВОТ
T.Prass the button "ON/OFF",
The programme runs.
B.At the end of the programma, swatch OFF
the machine by pressing the button "ON?
ПЕР"
ia
Opening the door / loading the
machine / closing the door
Opening the door
C» Presa the doors opening buttantFig. 2),
The door springs open.
Loading the machine
1 Any items which have been pre-treated
with solvent-based cleaners, such as stain
removers and petral-based agents must
be grad. Explosion hazard.
| Before loading the machina ensure that
there ane neither foreign obpects nor
tranped pets in the drum.
С»
Load
the
laundry
m
an
unfolded
and
bogsa
condition
in
the
drum,
mixing
large
and
small
(earns
Closing the door
| When closing the door make sure that
nothing із caught between the door and
the rubber seal
CO Close the door by pressing И shut unti it
snaps to wiih an audible click
Add detergent
Turn OW the tap
The tap must remain ON also during drying
аз drying occurs by condensation.
Your automatic washar/dryar сап be used
in three ways:
е uniriberrupped washing and drying
Note the followsng points:
For uninterrupted washing and drying. the
maximum load musi bae reduced to 2 or
1.5
Ка.
Cartain
types
of
laundry
may
not
yield
satisfactory
results
using
this
unin-
ierrupted made,
ihe most aconomical way te use your au
tomatic washerfdryer із to load maximum
amounts
for
washing
and
for
drying,
see
page 7
Setting the wash programme
1.Тият
the
prograenma
selector
clockwise
tà
the
desired
programme.
2 Set ihe temperature selector To the нон
quired temperature.
3.Set the drying time selector to D.
4 Press the buttons for additional functions
as required
90 on to "Starting the programma"
Setting the drylng programma
1.501
the
programme
selector
to
flow-heat drying)
2 501 the drying time selector to the re-
quired tima.
gà on to “Starting the programme"
Uninterrupted washing and drying
Y.
Turn
the
programme
selector
clockwise
10
the
desired
programme.
2.5at the temperature selector to the de-
sired temperature.
Збан the drying time to the required time.
A Press the butions for additional functions
as requirad.
Starting the programme
1 Make sure that the door is property closed.
2
Press
the
button
“ON/OFF,
The
ON
light
Шата
ее
and
the
programma
starts
Drying programme sequence
During drying the programme selector re
and will indicate tha remaining drying
time. During the last 16 minutes of the dry-
ing prograrnrme the laundry cools dawn. The
cooling-down phase is important te avoid
creasng
Г
Do
not
interrupt
the
cooling-down
phase.
13