Siemens 3100 - Cleaning the pump

f
pr
|
washing
Rinse Hold button pressed
The programme selector has stoppad at the
E
position.
The
laundry
remains
in
its
final
rinse
walter,
ou
nove
have
too
alternates:
a take the laundry from the machine while
still dripping wet
в spin the laundry |
Н you want to take the laundry eut drippeng
wel
1.Saitch OFF the machina.
2 Turn the programme selector to pump
position Р.
3. Switch the machina ON again
The rinse water is purnptid out маъа
spanning.
4. Switch OFF the machine,
After approximately 2 minutes you can
орап The door and remove the laundry,
И yeu want to spin the laundry:
O Press the "inse hold" bution again to ге-
turn it ta its normal position.
Tha water is now pumped aut and ihe
lanami 15 арил.
Rinse Hold burton nat pressed
Tha programme ends after the final spen
Switch OFF the machina.
Alter approximately 2 minutes you can open
tha door and remove the laundry.
Г И nacassary remove апу foresgn сорса,
[paper
сӛре,
coins
etc
|
from
the
drum
and
the rubber seal. Risk of rust damage.
<> Leave the door slighth opan so that the
machine can бгу aut.
End of programme / drying
Tha drying time selector has meched из end
position and door can now be openad.
1 Take the laundry aut of the machine en
Mediately по prevent creasing
Cotton and Enen items which have been
dried to "iron dry" should be rolled together
to prevent drying aut completely before
iraning.
= “Cupboard dry" items must be smoothed
out and folded together.
Easy-care/synthatics
= Hang shirts and bleuses individually on
hangers.
Cleaning / Maintenance / Frost protection
Cleaning your machine
| Never usa solvents as these can damage
machine components, produce naxious
vapour and constitute an explosion hazard.
| never spray the machine with a jet of
der
Housing and contro! panel should only be
cleaned with detergent solution or with a
standard, solvent-free, non-scouring сівап-
ing agent
Cleaning the detergent drawer
1.Pull the detergent drawer right out of the
machine (ovarcomang the spring catch
with а sighi tugl.
2 Clean gll parts under running water.
тағаты drawer in the mae
ching.
Descaling the machine
Descaling is not usually necessary il you use
this right amount of detergent.
1 Gescaling agents contain acids which can
comode machine components and causa
discoloration of laundry
However, if you do want to descale your
washing machina, follow the manulacturer's
directions.
Cleaning the drum
Any rust, caused by metal objects left in the
machine, must be removed using а
chlarinatree cleaning agent (check tha de-
scriptian of contents on the pack], Never use
steal woal.
Water supply hose
To avoid water damage have the hose
checked by a specialist every Б years.
Cleaning the pump
ғо. О.б
The pump must be claanad.
= if the pump is blocked by some foreign
abyect, such as bution or paper сір, and
* alter washing very Tluffy itema.
Before cleaning the purnp water must be
drained from the machine. When a pump
із Боски up to 20 ters of water can run
pui-sn keep a bucket handy
Cleaning:
1, Remove the base panel from the front of
the machina.
| Sealding hazard. Allow hot suds to cool.
2 Take out the discharge hose, pull out the
plug and lat rassdual water drain off into a
shallow container. Repeat the operation
until tase is no water left in the machine.
3.Re-plug the discharge hose and push it
back into the machina.
4.Шазстамғ the pump cover.
5. Remove any foreign objects and fibrous
deposits. Clean the pump. H must be
posable to freaky rotate tha pump impellar.
В Screw the pump cover back on.
7 Raplace and close the base panel.
В Рош approximateby 2 litres of water into
ihe detergent drawer and run the pump
programme, This prevents detergent How-
ing unused into the drainage system іп
the course of a subsequent wash cycle.