Transport, storage and packing
9229 9860 176 0E 11
2013-08-22
Transporting without
brackets
• Only lift the vacuum circuit-breaker far enough to put all sling gear under ten-
sion.
• Remove angle plate and bracket screws from the pallet.
• Lift the vacuum circuit-breaker from the pallet.
• Remove all screw connections from the brackets on the pole plate and the ter-
minals.
• Remove angle plate below mechanism box.
• Transport to installation site or leave suspended from crane for further work
steps.
Fig. 12 Removing screws from the pallet Fig. 13 Removing the angle plate and brackets
Siemens Parts
To Next Page
Loading...
