Transport, storage and packing
12 9229 9860 176 0E
2013-08-22
Unpacking (III)
Working equipment Required tools:
- Screwdriver
- Knife/scissors
- Lifting equipment with lifting gear.
Opening the transport unit • Place the transport unit on a level, non-slip and pressure-resistant surface.
• Remove lifting gear or transport means.
• Unscrew all the screws from the cover and lift it off.
• Remove partitions and store safely in the packaging for later attachment.
Note
Do not use the vacuum circuit-breaker if parts are broken, i.e. if you find cracks,
flaking, bent metal parts, damaged plug-in contacts, tears or bare cables.
Send it back in its original transport unit (see “Reusing the transport unit”,
page 15).
Fig. 14 Removing the cover Fig. 15 Taking out the partitions
To Next Page
Loading...
