Transport, storage and packing
9229 9860 176 0E 7
2013-08-22
• Remove partitions and accessory pack and store safely in the packaging for
later attachment.
• Remove film from the vacuum circuit-breaker.
• In the case of overseas packaging, push the lower film onto the pallet floor.
• Check the delivery is complete.
• Check vacuum circuit-breaker for damage.
• If the vacuum circuit-breaker is damaged, ship it back in the original transport
unit (see “Reusing the transport unit”, page 15).
Transporting with pallet,
without carton
The vacuum circuit-breaker can be transported with the pallet, without the carton.
• Thread carrying straps under the pallet or
• transport with fork lift.
Note
Do not use the vacuum circuit-breaker if parts are broken, i.e. if you find cracks,
flaking, bent metal parts, damaged plug-in contacts, tears or bare cables.
Send it back in its original transport unit (see “Reusing the transport unit”,
page 15).
Note
Carrying straps may scrape along the vacuum circuit-breaker and damage it.
If necessary, cover carrying straps with edge protection.
Select length and position of the carrying straps so that the pole heads are not
compressed.
Fig. 4 Removing partitions and film Fig. 5 Transporting with pallet possible
Siemens Parts
To Next Page
Loading...
