1. Screw on the cover ④ and ⑦ as far as it will go.
Make sure that there is no gap between enclosure and cover.
2. Secure each cover with the cover catch ③ and ⑥ by removing the screw.
3. Close the cover over the buttons①.
4. Tighten the screw for the cover over the buttons.
5. Check the tightness of the blanking plug ⑤ and cable gland ② in accordance with the
degree of protection.
Connecting
5.2 Connecting the device
SITRANS P320/P420 with 4 to 20 mA/HART
42 Compact Operating Instructions, 09/2018, A5E38874562-AB
To Next Page