Siemens 7UT513

$SSHQGL[87
9

&*&
Annunciations 7UT51X for PC, LC-display and binary inputs/outputs
²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²
FNo. - Function number of annunciation
Op/Ft - Operation/Fault annunciation
C/CG: Coming/Coming and Going annunciation
M : Measurand
Ear - Earth fault annunciation
IO - I: can be marshalled to binary input
O: can be marshalled to binary output (LED, trip/signal relais)
¿©©©©§©©©©©©©©©©©©©§©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©§©©§©©§©©©§©©¤
FNo.Abbreviation  Meaning OpFtEarIO
¨©©©©ª©©©©©©©©©©©©©ª©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©ª©©ª©©ª©©©ª©©
 3>Time Synchro>Time synchronization C   IO
 4>Start FltRec>Start fault recording    IO
 5>LED reset >LED reset    IO
 7>ParamSelec.1>Parameter set selection 1 (with No.8)    IO
 8>ParamSelec.2>Parameter set selection 2 (with No.7)    IO
 11>Annunc. 1 >User defined annunciation 1 CG  IO
 12>Annunc. 2 >User defined annunciation 2 CG  IO
 13>Annunc. 3 >User defined annunciation 3 CG  IO
 14>Annunc. 4 >User defined annunciation 4 CG  IO
 51Dev.operativeDevice operative / healthy CG   O
 56Initial startInitial start of processor system C    
 60LED reset LED Reset C    
 95Param.runningParameters are being set CG   O
 96Param. Set A Parameter set A is active CG   O
 97Param. Set B Parameter set B is active CG   O
 98Param. Set C Parameter set C is active CG   O
 99Param. Set D Parameter set D is active CG   O
 100Wrong SW-versWrong software-version C    
 101Wrong dev. IDWrong device identification C    
 110Annunc. lost Annunciations lost (buffer overflow) C    
 111Annu. PC lostAnnunciations for PC lost C    
 115Flt.Buff.OverFault annunciation buffer overflow  C   
 120Oper.Ann.InvaOperational annunciations invalid CG   
 121Flt.Ann.InvalFault annunciations invalid CG   
 124LED Buff.InvaLED annunciation buffer invalid CG   
 129VDEW-StateInvVDEW state invalid CG   
 135Chs Error Error in check sum CG   
 136Chs.A Error Error in check sum for parameter set A CG   
 137Chs.B Error Error in check sum for parameter set B CG   
 138Chs.C Error Error in check sum for parameter set C CG   
 139Chs.D Error Error in check sum for parameter set D CG   
 141Failure 24V Failure of internal 24 VDC power supplyCG   O
 143Failure 15V Failure of internal 15 VDC power supplyCG   O
 144Failure 5V Failure of internal 5 VDC power supply CG   O
 145Failure 0V Failure of internal 0 VDC power supply CG   O
 151Failure I/O 1Failure in I/O module 1 CG   O
 152Failure I/O 2Failure in I/O module 2 CG   O
 154Failure RKA Failure in the RKA module CG   
 159LSA disruptedLSA (system interface) disrupted CG   
 161I supervisionMeasured value supervision of currents     O
 163Failure IsymmFailure: Current symmetry supervision CG   O
 203Flt.RecDatDelFault recording data deleted C    
 204Flt.Rec.viaBIFault recording initiated via bin.inputC    
 205Flt.Rec.viaKBFault recording initiated via keyboard C    
 206Flt.Rec.viaPCFault recording initiated via PC interfC    
    
 301System Flt Fault in the power system CGC   
¥©©©©¦©©©©©©©©©©©©©¦©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©¦©©¦©©¦©©©¦©©¾
www . ElectricalPartManuals . com