To Next PageTo Next Page
Need help?Do you have a question about the Siemens 7UT512 and is the answer not in the manual?
General| Current Input | 1 A or 5 A |
|---|---|
| Rated Current | 1 A or 5 A |
| Frequency | 50 / 60 Hz |
| Current Transformer Inputs | Up to 6 |
| Communication Interfaces | IEC 61850 |
| Protection Functions | Overcurrent protection, Earth fault protection |
| Standards Compliance | IEC 60255, IEC 61850 |
| Operating Temperature | -25 °C to +70 °C |
Specifies the setting ranges, pick-up characteristics, times, tolerances, and influence variables for transformer differential protection.
Details the setting ranges, pick-up characteristics, times, tolerances, and influence variables for generator/motor differential protection.
Outlines setting ranges, pick-up characteristics, times, tolerances, and influence variables for branch-point differential protection.
Provides setting ranges, pick-up characteristics, times, tolerances, and influence variables for restricted earth fault protection.
Specifies characteristics, pick-up/times, tolerances, and influence variables for overcurrent time protection.
Details setting ranges, trip time characteristics, tolerances, and influence variables for overload protection.
Covers setting ranges, trip delay times, tolerances, and measured values for tank leakage protection.
Details the principle of measurement, evaluation of values, and stabilization for transformer protection.
Explains the principle of measurement and evaluation of measured values for generator and motor protection.
Covers the principle of measurement, evaluation of values, and stabilization for branch point protection.
Details the principle and evaluation of measured values for restricted earth fault protection.
Details procedures for parameterizing, selecting sets, setting date/time, and configuring transformer, generator, and branch point data.
Provides guidelines for conducting tests and commissioning the relay's protection functions.
