Siemens A70 User Guide

© Siemens AG 2004, C:\Siemens\DTP-Satz\Produkte\A70_Dorado_4\out-
left page (4) of A70 Dorado, 140mm, en, A31008-H2770-A1-4-7619 (23.09.2005, 08:38)
Making a phone call
4
VAR Language: en2; VAR issue date: 050331
End call
Press the End key
B
briefly. Press this key
even if the person on the other end of the
line has hung up first.
Set volume
Use the scroll keyEto start adjusting
the volume during conversation. Set vol-
ume with
G.
Redial previous numbers
To redial the phone number last called,
press the Call keyAtwice. To redial other
numbers that were dialled previously,
pick out the required phone number from
the list with
G, then pressAto dial.
When a number is busy
For automatically dialling the phone
number for up to 15 minutes at increas-
ing intervals, press §Auto dial§. For phone
ringing when the busy number is free,
press §Call back§ (
L
). Press §Prompt§ and a
beep will remind you to redial the dis-
payed phone number after 15 minutes.
Accept call
The phone must be switched on (standby
mode). An incoming call will interrupt
any other use of the phone.
Press §Answer§ or
A.
If the phone number has been transmitted
by the network, it is displayed. If the number
and the name are stored in the Phonebook,
the corresponding name is displayed in-
stead. If set, an animation can be dis-
played instead of the bell icon.
Reject call
§Reject§ or B press briefly.
Held call
Make a new connection during a call with
y menu§ ¢ Hold ¢
J
(dial new phone
number, also from Phonebook:
F
). With
§Swap§ you can swap back and forth be-
tween both calls.
Additional costs will be incurred for the
2nd phone connection.
Conference b
Make a new connection during a call with
y menu§ ¢ Hold ¢
J
(dial a new phone
number).
With
y menu§ ¢ Conference you can join
the held call. Repeat this procedure until
all participants are linked together (up to
5participants).
All calls in the conference are ended si-
multaneously when the End key
Bis
pressed.
Additional costs will be incurred for
every additional phone connection.
Call menu
Several functions are only available dur-
ing a call:
y menu§ ¢ Select a function.
Direct call
The phone can be locked, so it's only pos-
sible to dial a defined number.
Switch on
§Menu§ ¢ Setup ¢ Security ¢ Direct call
Press §Select§ and enter phone code. When
first prompted you define and enter the
phone code (4 - 8 digits). Please do not for-
get this code! Confirm input with §OK§ and
press §Change§. Select phone number from
the Phonebook (p. 5) or enter a new one.
With §OK§ confirm On.
Use
Press and hold the right soft key>to
dial.
Switch off
Press and hold

and enter phone code.
Confirm input with §OK§ and press
§Change§. With §OK§ confirm Off.

Siemens A70 Specifications

General

Brand	Siemens
Model	A70
Category	Cell Phone
Language	English