Disposal en
17
Fault Cause and troubleshooting
Time not displayed
when appliance
switched off
Display switches itself off after a short time.
No action required.
14.2 Information on display panel
Fault Cause and troubleshooting
Message showing "D"
or "E" appears in the
display.
Malfunction
1.
Reset appliance.
‒ Either press and hold for at least 6 seconds.
‒ Or switch off the circuit breaker or fuse in the electrical panel. Switch the fuse back
on after approx. 10 seconds.
a If the fault was a one-off, the message will disappear.
2.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→"Customer Service", Page18
Disposal
15 Disposal
15.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
1.
Unplug the appliance from the mains.
2.
Cut through the power cord.
3.
Dispose of the appliance in an environmentally
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
To Next Page
Loading...
Need help?
General
