49
en
Transport protection
Service programme to prevent frost damage
during transportation and storage.
This programme completely empties the
appliance.
Touch [ Start ] to begin running the
programme.
Empty the water tank and reinsert.
If available remove the milk container and
close the door.
The appliance automatically empties all its
pipes.
Empty the drip tray and re-insert.
Beverage info
Display shows how many drinks have been
prepared since its initial use.
Touch [ Display ] to show the information.
Factory settings
when delivered.
Select “Reset” with the rotary selector.
The message “Are you sure?” appears.
Touch [ Reset ] or [ Cancel ] to either
Care and daily cleaning
Risk of electric shock!
Never immerse the appliance in
water. Do not steam-clean the
appliance.
Wipe the outside of the appliance with a
soft, damp cloth.
cloth.
Do not use any cleaning agents
containing alcohol or spirits.
Do not use abrasive cloths or cleaning
agents.
Always remove any limescale, residues
of coffee or milk, cleaning or descaling
solution immediately. It is possible for
corrosion to form underneath such
deposits.
New sponge cloths may contain
salts. Salts can cause rust film on
stainless steel and must therefore be
washed out thoroughly before use.
Open the door, pull the drip tray forward
and remove the coffee grounds container.
Empty, clean and dry them both.
Important: The drip tray and the
coffee grounds container should be
emptied and cleaned every day to
prevent the formation of mould.
To Next Page
Loading...
Need help?
General
