Siemens CT636LE Series - Descaling and Cleaning Cycles

54
en
Descaling
Takes about 21 minutes.
Press button .
Turn the rotary selector to select
“Descale”.
Press button . Display indi-
cates progress of the programme.
Empty drip trays and replace.
press .
Pour lukewarm water into the empty
water tank up to the “0.5 l” mark and
then dissolve one Siemens descaling
tablet TZ80002 in it. For the TZ60002 you
should always dissolve two tablets.

If there is not enough descaling
solution in the water tank, you will
be asked to do the following.
using uncarbonated water and press
 again.
the right side of the beverage outlet with
the magnet.
Close the appliance door.
Place a container with a capacity of
0.5 litre under the beverage outlet.
Put the end of the milk tube into the
container.
Press button . The descaling
programme will now run for about
19 minutes.
.
Fill the tank with fresh water up to the
“max” indicator.
door.
Place the container underneath the
beverage outlet again.
Put the end of the milk tube into the
container.
Press button . The descaling
programme will now run for about
2 minutes and rinse the appliance.
trays, replace and close the appliance
door.
Press . The appliance has
again.
Press  to exit the program.
Cleaning
Takes about 5 minutes.
Press button .
Turn the rotary selector to select “Clean”.
Press button . Display indi-
cates progress of the programme.
Clean the beverage outlet and replace,
empty the drip trays and replace.
Open the ground coffee drawer, drop in
a cleaning tablet and close the coffee
drawer again.
Close the appliance door.
Place a container with a capacity of
0.5 litre under the beverage outlet.
Press button . The cleaning
programme will now run for about
5 minutes.
trays, replace and close the appliance
door.
Press . The appliance has
again.
Press  to exit the program.