55
en
calc’nClean
Takes about 26 minutes.
calc’nClean combines the functions Descale
and Clean. If both programmes are due
to be carried out close together, the fully
automatic coffee machine will automatically
suggest this service programme.
Press button .
Turn the rotary selector to select
“calc’nClean”.
Press button . The display
indicates the progress of the programme.
Clean the beverage outlet and replace,
empty the drip trays and replace.
Open the ground coffee drawer, drop in
a cleaning tablet and close the coffee
drawer again.
and press
Pour lukewarm water into the empty
water tank up to the “0.5 l” mark and
then dissolve one Siemens descaling
tablet TZ80002 in it. For the TZ60002 you
should always dissolve two tablets.
If there is not enough descaling
solution in the water tank, you will
be asked to do the following.
using uncarbonated water and press
again.
the right side of the beverage outlet with
the magnet.
Close the appliance door.
Place a container with a capacity of
0.5 litre under the beverage outlet.
Put the end of the milk tube into the
container.
Press button .
The programme will now run for about
19 minutes.
.
Fill the tank with fresh water up to the
“max” indicator.
door.
Place the container underneath the
beverage outlet again.
Put the end of the milk tube into the
container.
Press button .
The programme will now run for about
7 minutes and rinse the appliance.
trays, replace and close the appliance
door.
Press . The appliance
is descaled, cleaned and ready for
use again.
Press to exit the program.
Special rinsing
Important: If any of the service
programmes is ever interrupted, for
instance by a power failure, please
proceed according to the information
on the display:
water up to the “max” mark.
Press button . The
programme will now run for about
2 minutes and rinse the appliance.
Empty the drip trays, replace and close
the appliance door. The appliance is
ready for use again.
Press to exit the program.
To Next Page
Loading...
