Information and Communication
Communication Devices
3.2.2Fault Symptom on GSM-Tester:
This fault cannot be detected with a GSM-Tester
3.3Priority:
........ Mandatory
........ Repair
........ Optional
........ Not Yet Defined
3.4Repair Documentation
3.4.1Description of procedure:
3.4.1.1Diagnosis
Check the status of the fuse by measuring its resistance with
a multimeter. The fuse is defective if the resistance higher than 10
ohms.
3.4.1.2Repair by component change
Use soldering iron to remove defective fuse.
Avoid excessive heat!
Watch surrounding components!
Resolder new fuse afterwards.
3.4.1.3Repair by SW-Booting
Not possible!
V1.2 Page 9 of 22 ICP CD ST
D. Schnoor
06/98
To Next Page
Loading...
