Siemens EQ.500 TQ503D01 - Using the cleaning programme; Using calcnClean

en Cleaning and servicing
66
4. To start the programme, press ⁠.
a The display will guide you through
theprogramme.
5. Empty and insert the drip tray.
6. Remove and empty the milk con-
tainer.
7. Clean the milk container, milk tube
and suction pipe.
8. Fit the components and insert the
milk container.
9. If there is a water filter, remove it.
10.Press ⁠.
11.Empty the water tank.
12.Fill a container with 0.5l lukewarm
water.
13.Add a Siemens descaling tablet to
the water and stir until the tablet is
fully dissolved.
14.Pour the descaling solution into the
water tank up to the calc mark and
press ⁠.
15.Place the empty container under the
outlet system and press ⁠.
a The descaling programme will run
for approx.20minutes.
16.Rinse the water tank.
17.Press ⁠.
18.If there is a water filter, insert the wa-
ter filter.
→"Insert water filter", Page58
19.Press ⁠.
20.Fill the tank with fresh water up to
the "max" mark.
21.Press ⁠.
a The descaling programme takes ap-
prox.1minute and rinses the appli-
ance.
22.Empty and insert the drip tray.
23.Remove and empty the milk con-
tainer.
24.Clean the milk container, milk tube
and suction pipe.
25.Fit the components and insert the
milk container.
a The program has ended and the ap-
pliance is ready for operation.
Using the cleaning programme
Run the cleaning programme when
your appliance prompts you. The pro-
cess takes approx.9minutes.
Requirement:The brewing unit is
cleaned.
→"Cleaning brewing unit", Page64
1. Press ⁠.
2. Use and to select "Cleaning
and care" and press ⁠.
3. Use and to select "Clean"
and press ⁠.
4. To start the programme, press ⁠.
a The display will guide you through
theprogramme.
5. Empty and insert the drip tray.
6. Open the ground coffee compart-
ment.
7. Place one Siemens cleaning tablet
into the ground coffee compartment.
8. Close the ground coffee compart-
ment and press ⁠.
9. Place a container with a capacity of
min. 0.5l under the outlet system
and press ⁠.
a The cleaning programme takes ap-
prox. 7minutes.
10.Empty and insert the drip tray.
a The program has ended and the ap-
pliance is ready for operation.
Using calc'nClean
You can combine the cleaning and de-
scaling programmes using the
calc'nClean service programme. Run
the calc'nClean programme when your
appliance prompts you. The process
takes approx.43minutes.
Requirement:The brewing unit is
cleaned.
→"Cleaning brewing unit", Page64