Siemens Euroset 3005 - Quick Reference Guide

10
Quick Reference Guide
FUNCTION PROCEDURE
VERIFYING THE DIALING
MODE ( TONE/P ULSE)
• Press any numeric key. If you still hear the dialling tone, change to
the other dialling mode.
• The switch located on the bottom of the telephone allows you to do
three adjustments:
SWITCHING THE DIALLING
MODE (TONE / PULSE)
P PULSE (decadic)
T1 TONE flash 100 ms
T2 TONE flash 270 ms
TEMPORARY CHANGOVER
OF DIALLING MODE (TONE /
PULSE)
After establishing a call, change to TONE by pressing the
key
(i.e. to use telebank services).
Lift the handset
+ Press the MUTE key followed by the key
...
Press one of the 0 to 9 keys
Press the MUTE key
SETTING THE RINGER
VOLUME / MELODY
Hung up
REDIAL To redial the last dialled number, press the key .
MUTE
By pressing the MUTE key
during a call, the handset will
deactivate the voice transmission. To go back to
conversation, press the MUTE key again.
FLASH
Press the FLASH key
to access specific special services
(follow me, call waiting, conference, etc.).
+
Lift the handset and press the MUTE key
Press the desired one-touch memory key
...
Enter the phone number to be stored
PROGRAMMING THE ONE-
TOUCH MEMORIES
Press the MUTE key
Lift the handset
USING THE ONE-TOUCH
MEMORIES TO MAKE A CALL
Press the desired one-touch memory key
+
Lift the handset and press the MUTE key
Press the MEM key
...
Press the desired memory number (0 to 9)
...
Enter the phone number to be stored
PROGRAMMMING THE TWO-
TOUCH MEMORIES
Press the MUTE key
Lift the handset
Press the MEM key
USING THE TWO-TOUCH
MEMORIES TO MAKE A CALL
...
Press the desired memory number (0 to 9)