Siemens EX8 LX6 Series - Cookware and cooking results check; Home Connect settings

Basic settings en
45
--------
™‚ƒ
Check the cookware and the cooking results
‹ Not suitable
‚ Not perfect
ƒ Suitable
™‚„
Configuring activation of the flexible cooking zone
‹ As two independent cooking zones.
‚ As a single cooking zone.*
™‚…
Connecting the wireless cooking sensor to the hob
‹ Connected correctly
‚ Not connected correctly: Transmission error.
ƒ Not connected correctly: Temperature sensor fault.
™‚ˆ
Setting air recirculation mode or air extraction mode
‹ Configuring air recirculation mode.*
‚ Configuring air extraction mode.
™‚‰
Setting the automatic start
‹ Switched off.
‚ Switched on: Automatic mode with sensor control.*
ƒ Switched on: The ventilation system starts at a power level in accordance with the relevant power levels for the cooking zones.
™‚Š
Setting sensor sensitivity for the ventilation system
‚ Lowest sensor sensitivity setting.
ƒ Medium sensor sensitivity setting.*
„ Highest sensor sensitivity setting.
™ƒ‹
Setting the run-on
‹ Switched off.
‚ Switched on: Automatic function with sensor-controlled run-on.
ƒ Switched on*:
If the hob is working in air extraction mode, the ventilation system switches itself on for approx. six minutes at power level „.
If the hob is working in circulating-air mode, the ventilation system switches itself on for approx. 30 minutes at power level ‚.
The run-on function automatically switches off after this time.
™ƒ†
Automatic pot detection
‹ Deactivated: Select the required cooking zone manually.
‚ Activated: The hob detects the size and the position of the pot and selects the corresponding cooking zone(s)*.
•’
Home Connect
~ "Home Connect settings"
™‹
Restore to standard settings
‹ Individual settings.*
‚ Restore factory settings.
*Factory setting
**The hob's maximum power output is shown on the rating plate.