What to do if there is a mains failure with Siemens FT2010?
If there is a mains failure in the public network when using Siemens Touch terminals, no action is needed. The emergency power supply is ensured by batteries for a minimum of 12 hours, and up to 72 hours depending on the customer specification. If the fuse is damaged, check the fuses (current distributor of the building) and replace them if necessary.
What to do if the automatic detector is missing in Siemens Touch terminals?
If the automatic detector is missing from your Siemens Touch terminals, re-insert the 'Detector'. If the 'Detector' is defective, replace it with a replacement detector of the same type. Be cautious when replacing the 'Detector'; always use the same type.
General| Resolution | 800 x 600 pixels |
|---|---|
| Power Supply | 24 V DC |
| Protection Class | IP65 (front) |
| Display | TFT |
| Touch Technology | Resistive |
| Processor | Intel Atom |
| Interfaces | 2x USB, 1x RS232 |
| Operating System | Windows Embedded Standard |
| Enclosure | Aluminum front, plastic back |
| Operating Temperature | 0 to 50 °C |
To Next Page
