AL18H / RUS EN for Russia / A31008-M2052-S301-1-9U19 / starting.fm / 04.11.2008
5
Registering the handset to the base station
Before you can use the phone, you must first register the handset to the base station.
The actual registration procedure will depend on the type of base station.
Automatically register the AL18H handset to the Gigaset AL180/AL185 base station
Manually registering the AL18H handset
You must activate manual registration of the handset on both the handset and the
base station.
1. On the handset:
MENU ¢ Settings ¢ OK ¢ Handset ¢ OK ¢ Register HS
¢ Enter the base station system PIN (default setting: 0000) ¢ OK.
2. On the base station: Wi
thin 60 sec. of entering the system PIN, press and hold the reg-
istration/paging key (min. 3 sec.). See also the user guide belonging to the base station.
After successful automatic or manual registration, the idle display is shown:
The handset is assigned the lowest unassigned internal number (1–4). If more than one
handset is registered to the base station, the internal handset number appears in the top
left of the display, e.g. 2. If the internal numbers 1–4 are already assigned to other
devices, the number 4 will be overwritten.
Please note
Only place the handset in the base station or c
harging cradle that is intended for it.
V
Registering
The handset registers automatically.
Registration can take up to 5 minutes.
Do not remove the handset from the
base station during this time.
V
Put into base
MENU
¤ Place the handset with
the display facing up in
the base station.
V
Registering
The registration screen is displayed.
V
INT MENU
Charge status of the batteries:
–
= e V U (flat to full)
–
= flashes: batteries almost flat
–
e V U flashes: charging
To Next Page
Loading...