Siemens Gigaset AS28H - Registering the handset to the base station; Automatically register the AS28 H handset to the Gigaset AS280 DUO;AS285 base station; Manually register the AS28 H handset

AS28H Handset / Israel EN / A31008-M2051-B501-1-VU19 / starting.fm / 19.02.2009
5
Registering the handset to the base station
Before you can use the phone, you must first register the handset to the base station.
The actual registration procedure will depend on the type of base station.
Automatically register the AS28H handset to the Gigaset AS280DUO/AS285 base station
Manually register the AS28H handset
You must activate manual registration of the handset on both the handset and the
base station.
1. On the handset:
MENU ¢ Settings ¢ OK ¢ Handset ¢ OK ¢ Register HS
¢ Enter the base station system PIN (default setting: 0000) ¢ OK.
2. On the base station: Wi
thin 60 seconds of entering the system PIN, press and hold the
registration/paging key (min. 3 seconds). See also the user guide for the base station.
After successful automatic or manual registration, the idle screen is displayed:
The handset is assigned the lowest unassigned internal number (1–4). If more than one
handset is registered to the base station, the internal handset number appears in the top
left of the display, e.g. 2. If the internal numbers 1–4 are already assigned to other
devices, number 4 will be overwritten.
Please note
Only place the handset in the base station or c
harging cradle that is intended for it.
V
Registering
The handset registers automatically.
Registration can take up to 5 minutes. 
Do not remove the handset from
the base station during this time.
V
Put into base
MENU
¤ Place the handset with
the display facing up
in the base station.
V
Registering
The registration screen is displayed.
V
INT MENU
Charge status of the batteries:
–
= e V U (flat to full)
–
= flashes: batteries almost flat
–
e V U flashes: charging