EasyManua.ls Logo

Siemens GS32NS52 - Installation Location; Ambient Temperature and Ventilation; Changing over the Door Hinges; Appliances with Glass Front

Siemens GS32NS52
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
en
6
Installation location
A dry, well ventilated room is suitable as
an installation location. The installation
location should not be exposed to direct
sunlight and not placed near a heat
source, e.g. a cooker, radiator, etc. If
installation next to a heat source is
unavoidable, use a suitable insulating
plate or observe the following minimum
distances from the heat source:
3 cm to electric or gas cookers.
30 cm to an oil or coal-fired cooker.
The floor of the installation location must
not give way; if required, reinforce floor. If
the floor is uneven, compensate with
supports.
Note
If installing the appliance next to another
refrigerator or freezer, ensure a minimum
lateral distance of 2 cm to prevent
the formation of condensation.
Ambient temperature
and ventilation
Ambient temperature
The appliance is designed for a specific
climate class. Depending on the climate
class, the appliance can be operated at
the following temperatures.
The climate class can be found on
the rating plate. Fig. *
Note
The appliance is fully functional within
the room temperature limits
of the indicated climatic class. If
an appliance of climatic class SN
is operated at colder room temperatures,
the appliance will not be damaged up to
a temperature of +5 °C.
Ventilation
Fig. 3
The air on the rear
panel of the appliance heats up.
Conduction of the heated air must
not be obstructed. Otherwise,
the refrigerating unit must work harder.
This increases power consumption.
Therefore: Never cover or block
the ventilation openings!
Changing over
the door hinges
The door hinges cannot be changed
over on this appliance.
Appliances with glass
front
ã=Caution
Risk of tipping over!
When opening the door, ensure that the
appliance does not tilt forwards. The
glass front may shatter if it comes into
contact with the floor!
The appliance must be attached to the
wall with the enclosed brackets.
The installation instructions are enclosed
with the brackets.
Climate class Permitted ambient
temperature
SN +10 °C to 32 °C
N +16 °C to 32 °C
ST +16 °C to 38 °C
T +16 °C to 43 °C

Related product manuals