Home Connect en
27
Disconnecting from the network
Di s connect i ng from the net wor k
You can disconnect your hob from the network at any
time.
Note:
If your hob is disconnected from the network, it is not
possible to operate it using Home Connect.
1. Touch the 0 symbol for 4 seconds.
Product information will be displayed.
2. Touch the 0 symbol repeatedly until the •’‚
setting appears.
„ lights up on the cooking position display.
3. Set the ‹ value on the control panel.
The appliance is disconnected from the home network
and the D symbol on the control panel goes out.
Connecting to the network
Connec t i ng to the net wor k
1. Touch the 0 symbol for 4 seconds.
Product information will be displayed.
2. Touch the 0 symbol repeatedly until the •’‚
setting appears.
‹ lights up on the cooking position display.
3. On the control panel
set the "Connect automatically" ‚ value or
or the "Connect manually" ƒ value.
4. Follow the instructions in the section entitled
"Automatic registration in the home network" or
"Manual registration in the home network".
Connect to the app
If the Home Connect app is installed on your mobile
device, you can connect it to your hob.
Notes
■ The appliance must be connected to the network.
■ The app must be open and be set up.
1. Touch the 0 symbol for 4 seconds.
Product information will be displayed.
2. Touch the 0 symbol repeatedly until the •’ƒ
setting appears.
‹ lights up on the cooking position display.
3. Set the ‚ value on the control panel.
4. Follow the instructions in the app to complete the
connection process.
Settings via app
Using the Home Connect app, you can easily access
the basic settings for your hob and send settings for the
cooking positions to the hob.
Notes
■ To change basic settings the hob must be switched
off.
■ Operation on the appliance always has priority.
During this time it is not possible to operate the
appliance using the Home Connect app.
■ The transfer of settings is activated when the
appliance is supplied.
■ If the transfer of settings has been deactivated, only
the hob's operating statuses will be displayed in the
Home Connect app.
1. Touch the 0 symbol for 4 seconds.
Product information will be displayed.
2. Touch the 0 symbol repeatedly until the •’…
setting appears.
3. To activate the transfer, select the ‚ value on the
control panel. To deactivate the transfer, select the ‹
value.
Confirming settings
As soon as cooking settings are transmitted to a
hotplate, the hotplate indicator will start to flash. To
confirm that you want to use these settings, touch the
indicator for the required hotplate. To reject these
settings, touch any other button on the hob.
To Next Page
Loading...
