Siemens iQ300 KF96NA Series - Operating Tips and Temperature Settings

en operation
42
2. Switch off the warning tone using
.
a goes out as soon as the set
temperature has been reached.
3. Set the required temperature.
→Page42
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The front and side panels of
thehousing heat up occasionally.
This prevents condensation from
forming.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
¡ The temperature in the appliance
varies due to the following condi-
tions:
– How often the appliance is
opened
– Load capacity
– Temperature of newly stored
food
– Ambient temperature
– Direct sunlight
7.3 Switching off the appli-
ance
▶ Disconnect the appliance from the
power supply. Unplug the appli-
ance from the mains or switch off
the circuit breaker in the fuse box.
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
▶ Press repeatedly until the
temperature display (refrigerator
compartment) shows the required
temperature.
The recommended temperature in
the refrigerator compartment is
4°C.
Setting the freezer compartment
temperature
▶ Press repeatedly until the
temperature display (freezer com-
partment) shows the required tem-
perature.
The recommended temperature in
the freezer compartment is
−18°C.
7.5 Button lock (childproof
lock)
The button lock prevents the appli-
ance from being operated accident-
ally or incorrectly while running.
Switching on the button lock
▶ Press and hold for
threeseconds.
a lights up.
Switching off the button lock
▶ Press and hold for
threeseconds.
a goes out.