en Additional functions
48
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The front panels of the housing are
temporarily heated slightly. This
prevents condensation in the area
of the door seal.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
▶ Press and hold for tenseconds.
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
1. Select the refrigerator compart-
ment using .
2. Press / repeatedly until the
temperature display (refrigerator
compartment) shows the required
temperature.
To reach the set temperature, slide
the temperature controller for the
storage container to a position that
is one third from the bottom.
→Page48
The recommended temperature in
the refrigerator compartment is
4°C.
Setting the storage container
temperature
1. To reduce the temperature, slide
the temperature controller in the
direction.
2. To increase the temperature, slide
the temperature controller in the
direction.
→Fig.
13
Setting the freezer compartment
temperature
1. Select the freezer compartment
with .
2. Press / repeatedly until the
temperature display (freezer com-
partment) shows the required tem-
perature.
The recommended temperature in
the freezer compartment is
−18°C.
7.5 Button lock (childproof
lock)
The button lock prevents the appli-
ance from being operated accident-
ally or incorrectly while running.
Switching on the button lock
▶ Press and hold for
threeseconds.
a lights up.
Switching off the button lock
▶ Press and hold for
threeseconds.
a lights up.
8 Additional functions
8.1 Super cooling
With Super cooling, the refrigerator
compartment cools as cold as pos-
sible.
Switch on Super cooling before pla-
cing large quantities of food.