Installation instructions en
19
15.
Secure the screw for the elongated hole in the view
frame on the motor block, but do not screw it in
completely.
16.
Hook the view frame onto the elongated hole and
tighten all of the screws.
17.
Insert both plug connections and hook on the
cables.
18.
Fit the cable cover.
19.
Fit the motor cover.
20.
Fit the grease filters.
21.
Fit the filter cover.
22.
Close the filter cover and engage the lock .
23.
Insert the mains plug and switch on the fuse again.
Removing the appliance
WARNING‒Risk of injury!
Components inside the appliance may have sharp
edges.
▶
Wear protective gloves.
1.
Disconnect the appliance from the power supply.
To Next Page
Loading...
