Siemens IQ500 LR97CAP21B - Setting Air Recirculation Mode

en Familiarising yourself with your appliance
6
5 Familiarising yourself with your appliance
5.1 Controls
The controls are used to configure all functions of your
appliance and to obtain information about the operat-
ing status.
Increase fan setting / intensive mode / switch
on appliance
Decrease fan setting / switch off appliance
Lighting
Intermittent mode
Fan run-on
5.2 LED display
The displays show set values and functions.
1 2 3 4 5 6 7
1
Fan setting 1
2
Fan setting 2
3
Fan setting 3
4
Intensive mode
5
Fan run-on
6
Intermittent mode
7
Saturation indicator
6 Accessories
You can buy accessories from the after-sales service,
from specialist retailers or online. Only use original ac-
cessories, as these have been specifically designed for
your appliance.
Accessories vary from one appliance to another. When
purchasing accessories, always quote the exact
product number (E no.) of your appliance. →Page12
You can find out which accessories are available for
your appliance in our catalogue, in the online shop or
from our after-sales service.
www.siemens-home.bsh-group.com
Accessories Order number
Odour filter for the
CleanAir recirculation
module
LZ21JCB11
CleanAir recirculation
module, stainless steel
LZ21JXC51
CleanAir recirculation
module, white
LZ21JXC21
7 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
7.1 Setting the appliance to air recirculation
mode
Your appliance is set to air extraction mode by default.
To use it in circulating-air mode, you must set the oper-
ating mode.
Requirement:The appliance is switched off.
▶
Press and hold for four seconds.
a An audible signal sounds.
a The LEDs for fan settings 1, 2 and 3, the LED for in-
tensive mode and the LED for the saturation indic-
ator light up in the LED display.
a The appliance is set to circulating-air mode.