Siemens IQ500 - Cleaning the Milk System; Notifications on the Display Panel; Rectifying Faults

en Rectifying faults
66
Errors Cause Troubleshooting
Appliance is not dispensing
hot water.
Milk system is soiled.
▶
Clean the milk system in the dish-
washer.
→"Cleaning the milk system",
Page60
Appliance is not dispensing
drinks.
Air is in the water filter. 1. Immerse the water filter in water with
the opening facing upwards until no
more air bubbles escape.
2. Reinsert the filter.
→"Insert water filter", Page56
▶
Firmly press the water filter straight
down into the tank connection.
There is dripping water on the
inner floor of the appliance.
Drip tray was removed too
soon.
▶
Wait a few seconds after the last
drink was dispensed before removing
the drip tray.
Brewing unit cannot be re-
moved.
Brewing unit is not in the re-
moval position (e.g. frost pro-
tection activated).
▶
Switch the appliance back on.
Appliance cannot be oper-
ated.
Change displays.
Appliance is in demo mode.
▶
To deactivate demo mode, press and
hold for at least 5seconds.
Grinder won't start. Appliance is too hot.
▶
Wait 1hour so the appliance can cool
down.
Notifications on the display panel
Errors Cause Troubleshooting
Display shows "Close" despite
the fact that the door is
closed.
Door is not properly closed.
▶
Press the door firmly shut.
Appliance is too hot.
▶
Wait 1hour so the appliance can cool
down.
Display shows "Please empty
drip tray and reinsert." despite
the fact that the drip tray is
empty.
Appliance is switched off and
does not detect emptying.
1. Switch the appliance on, and remove
the drip tray.
2. Re-insert the drip tray.
Drip tray is soiled.
▶
Clean the drip tray thoroughly.
Display shows "Please refill
water tank" despite the fact
that the water tank is full.
Water tank is wrongly inser-
ted.
▶
Insert the water tank correctly.
Carbonated water is in the wa-
ter tank.
▶
Fill the water tank with fresh tap wa-
ter.
Float is stuck in the water
tank.
1. Remove the water tank.
2. Clean the water tank thoroughly.